Push Blocks In Stock Now

Description

MicroJig Grr-rip Block (GB-1). Set of two push blocks that allows you to safely grip wood while cutting on the table saw, router table, planar, etc.

This tool’s features include:

• Large gripping surface
• “Smart” hooks that automatically retract if you place them mid board and engage at the board end to ‘hook’ the board
• 90 deg. flip guide for vertical footing
• Mounts for shield plate (not included in this set)

This set comes with a reusable tie to hold them together in transit.

Also known as: Grip block

Often Used With: Jobsite table saw

Intended Uses

These push blocks are intended to help you grip a piece of wood for non-through cutting applications, although you can use them for ripping or cross-cutting wood on the table saw. A non-through cut on a table saw is when the blade cuts only part way through the material, not completely through. A dado is an example of a non-through cut.

Special Instructions

If you do not want the hooks to drop automatically, pull them into their upright position past a “spring-like” detent. 

Tool Resources

Diagram

None at this time.

Instructions & Resources

• Video: “GRR-RIP BLOCK from Micro Jig, A First Look” (3:20 mins) by Ralph Bagnall. A first look, many years ago...this short video will give you an idea of the applications of the push block.