Digital Caliper, 6 in In Stock Now

Description

iGaging OriginCal Digital Caliper (100-700-33). This caliper measures up to six inches with a large digital display in inches (decimal and fractional) and millimeters.

Features of this item include:

• Resolution: 0.0005 in. /0.01 mm / 1/128-in fractions
• Accuracy: 0.001-in. / 0.02 mm
• Depth gauge
• Zero-setting at any position
• MM to inches switch at any position
• Large LCD display

Intended Uses

Used for accurate measurements up to six inches of inside or outside diameters or depth. This tool is extremely useful for measuring most bike parts.

Special Instructions

Please make sure the clamp screw is loosened before adjusting the slider. The protection rating is IP54–humidity and dust resistant, but not resistant to dropping, throwing, bending, flicking, etc., so please treat this tool delicately ;-)

This caliper takes a 3V CR-2032 lithium battery.

Tool Resources

Diagram

Image source: Operating Instructions and Parts Manual

Instructions & Resources

• Instructions derived from the Operating Instructions and Parts Manual:

Measurement:

1. Press ON/OFF key to switch power on
2. Press in/mm key to select desired unit system
3. Loosen the clamp screw for the slider if it isn’t already loose
4. When faces are closed (or touching each other) the LCD readout should read: 0.00mm (in mm mode). If it shows a number, then zero it out by pressing the origin button for 5 seconds until 0.00 appears.
5. Move the slider with thumb screw to take your inside, outside, or depth measurements.

From Absolute measurement to Incremental measurements:

1. By default, the caliper is set to Absolute. To use Incremental mode, begin by measuring your object in Absolute mode, then press ZERO/ABS switch–it will zero out the reading–then move slider either direction for additional measurements. Wherever you land, if you press the ZERO/ABS switch again, the reading will be your original measurement plus or minus the amount you moved the slider after switching modes.

Battery Replacement:

1. When replacing battery, the positive pole must face out. After replacement, close the jaws and hold down the ORIGIN switch for 5 seconds until 0.00 appears in the LCD display. Now the absolute zero setting is complete and you can begin measuring again!

• Web Copy: “How to Read Calipers” by Home Depot. This resource covers a few types of calipers including a digital version like this item.