Bicycle Repair Stand, Older Generation In Stock Now

Description

Park Tool Single Arm Repair Stand (PRS-6). This older generation bike repair stand is the pre-1996 model.

Features of this item include:

• 40 inches high (this is pretty low for bike stands!)
• 360 degree locking swivel on the jaws
• Sturdy, heavy base

Also known as: Floor stand, Work stand, Maintenance stand

Similar to: Bike Repair Stand

Intended Uses

Used to lift, hold, and stabilize your bicycle while you repair it. This older model can only accommodate older model bicycles with 1 or 1 ⅛ inch tubing. While you could use it to clamp on to seat posts (and dropper post stanchions), it won't get the bike off the ground by much if at all.

Special Instructions

The clamp on this bike stand is not adjustable–it can't accommodate oversized tubing on modern mountain bikes. The maximum recommended width of tubing is 1 ⅛ inch. 

If you clamp your dropper post stanchion, make sure you clean the clamp and/or place a clean cloth/nitrile glove over the clamp jaws so you don't mar the surface of the stanchion!

Tool Resources

Diagram

Not at this time!

Instructions & Resources

Not at this time!

This tool was donated by: Mathew, Thank-you!