Pliers, Snap Ring Set In Stock Now

Description

Park Tool Snap Ring Plier Set (# RP-SET.2). This is a set of 5 specialty pliers used to remove and install snap rings or c-clips.

Features of this item include:

• RP-1: 0.9mm straight internal — opens from 22mm down to 0 (tips touching)
• RP-2: 1.3mm bent internal — opens from 22mm down to 2mm (center to center)
• RP-3: 1.3mm bent external — opens from 2mm (center to center) up to 18mm
• RP-4: 1.7mm bent internal — opens from 21mm down to 2mm (center to center)
• RP-5: 1.7mm straight internal — opens from 25mm down to 0 (tips touching)

This set comes in a Milwaukee tough bag.

Also known as: C-ring Pliers; C-clip Pliers

Intended Uses

Used to remove and install snap/c rings found on various components such as: suspension, brakes, dropper posts, bottom brackets, and others.

The "external" in the "bent external" pair–RP-3–means that the ends start off close to each other and when you squeeze the handles, the ends pull away from each other.

Special Instructions

Please use these pliers on bicycle applications only! :) This set of pliers is specific to bike components–the snap rings on bike components are generally a bit smaller and not as robust as those found in other applications.

Says Park Tool (so you should listen!): "Always use the pliers with the largest pins that fit into the eyelets of the snap ring."

Tool Resources

Diagram

Not at this time!

Instructions

Not at this time!

Resources

• Video: "RP-SET.2 Snap Ring Pliers Set" by Park Tool (1:34m). Check out just the first minute of this video to see each of the pliers in this set in action.